Necessary Steps To Design Your Own Wireless Home Security System
Just like most other systems and gadgets which have the do-it-yourself tag, you can now even Design Your Own Wireless Home Security System and avoid the service fees. It takes you just about thirty minutes to complete the installation and you are totally relieved of all installation charges or contracts.
All That You Need
You have to buy all the parts required to Design Your Own Wireless Home Security System. The normal components of a Home security system are a control console, door and window sensors, motion detectors, a lamp module and a remote control, with an additional keychain remote as well.
The countertop console looks like an answering machine and the door and window sensors operate on batteries. You can have as many sensors as you need for the entire house. The motion detector is infrared and is easy to mount, and could also be put in different places in the house.
There is no mounting necessary for the lamp module as it is possible to fit it into any electrical socket. The remote control is necessary as it dims and brightens lighting anywhere in the house. The keychain remote is what you carry all the time.
Installation
After you have acquired all the necessary parts to Design Your Own Wireless Home Security System, the installation begins. You just need large and small Philips head screwdrivers to fit in everything.
The first step is positioning the console. It could be located right in the middle of the house, to make it easy to reach in an emergency. Wall mounting is also possible and the favorite spots are a kitchen countertop or a hallway table. The control console has to be plugged into a power source and a telephone jack with the help of the cords which are provided with the box.
A battery backup is also necessary, for which you put in a 9 volt battery, so that the system can run even when there is no power in your house. Record your message on the console after that by following the instructions for which buttons have to be pressed in order to start the recording. The message is for the emergency contacts who can hear this recorded message. Don’t forget to choose numbers belonging to your neighbors, friends or relatives and program them as emergency numbers.
Placing the sensors, the motion detectors and the lamp module is the next step to Design Your Own Wireless Home Security System. You have to start thinking like a burglar and imagine which areas he would target if he wanted to rob your house. Choose good hiding spots for the sensors, so that thieves cannot see them. Put motion detectors on the corner of the room, so that the whole room can be seen.
Hide door and window sensors as well, maybe inside door jambs or behind curtains. Put batteries in each sensor and mount them on the walls. If you don’t want to use hardware, just use double sided foam tape to protect your walls.
Activation
Now activate your system, and check out whether all sensors, detectors and remotes have been successfully activated. After all, you have taken the trouble to Design Your Own Wireless Home Security System, now you must go from sensor to sensor and ask someone to stand near the console to check whether they are effective. If there is a chime each time, your installation has been successful.
|
