|
Checking And Replacing The Belt For Treadmill Damages |
By:
Chloe Adisson |
|
|
Checking And Replacing The Belt For Treadmill Damages
Chloe Adisson
Your walking belt for treadmill is more delicate because it is more exposed to contact and therefore prone to damage. This article explains the general pointers in doing a check up on the belt as well as how to replace it. How do you check signs of damages?
The major components of the treadmill that require special attention are the deck and the belt. If the belt is not properly taken cared of, the deck's mechanical operation will also get affected.
Keeping the belt in good shape is important especially if you're using the treadmill everyday. You will know if your belt needs replacement if you notice these items.
- When there are curls on the edges.
- The treadmill speed slows down when you step onto the deck.
- There obvious grooves appear on your treadmill belt.
Replace the belt when it looks generally worn-out. Otherwise, it may only need lubrication or waxing to keep it functional.
If you notice obvious indications or signs of wear and tear, it's time for you to do a belt replacement. If you do not have the instruction manual, here are the basic instructions.
Removing the belt
- Unplug the treadmill. Make sure your treadmill is not connected to a power supply.
- Locate the hood of the treadmill's motor and remove it.
- Loosen and remove the screws on both sides to take out the rear roller. These are the same screws affecting the tension of the belt.
- Do the same for the front roller by loosening the front end screws. Incline the board if the screws are not accessible.
- Once the screws are removed, you can now take out the front and rear rollers.
- The next step is to remove the belt.
Replacing the belt for treadmill
- You need to lay the new belt and deck together. Slide the belt over the deck and align.
- Install the rollers and fasten the deck to the frame properly and securely.
- Fasten the belt and deck together with screws. You may need to adjust the deck to get the screws in.
- Slide the belt in through the rear roller by pulling it to the rear end.
- Adjust and tighten the screws a bit to hold the parts together.
- Replace the drive motor belt over the drive gear by sliding the front roller inside the belt.
- Tighten the screws of the front and rear rollers until the belt fits snuggly on the deck.
- Adjust the belt. The adjustment concept is done by changing the speed to test the tightness and feel of your belt.
The process may sound simple but if you haven't done this before, it's best not to do it yourself. Seek help from someone who has more experience in replacing a belt for treadmill.
Apply a http://www.bestexercisetreadmills.com/) treadmill belt lubricant to maintain the http://www.bestexercisetreadmills.com/folding-treadmill.html belt for treadmill. Discover more tips online.
|
|
Article Source: http://www.statssheet.com/articles/article67684.html |
|
|
|
|
|
